DSC PC1404 v1.1 Instrukcja Użytkownika Pobierz pdf (Strona 10)

Disarming from an LCD Alphanumeric Keypad:

Disarming from an LCD Fixed Message/Icon Keypad

Enter your access code to disarm anytime the system is armed (Armed ( ) indicator is on). The key-

pad will beep if you walk through the entry door. Enter your code within _____ seconds to avoid an

alarm condition (please check with your installer to have this time programmed).

Disarming Error

If your code is invalid, the system will not disarm and a 2-second error tone will sound. If this hap-

pens, press [#] and try again.

NOTE: If you return and find that an alarm has occurred while you were away, it is possible

that an intruder may still be on the premises. Go to a neighbour's house, and call the local

police to investigate.

NOTE: The alarm memory is cleared each time the panel is armed so that any alarms

showing are alarms that occurred only during the last armed period.

Access Codes

Access codes are used to arm and disarm the system. There are 40 access codes available: 1 master

code and 39 user codes.

Only the Master Code can be used to program additional security codes and to change other system

features, as well as to arm and disarm the security system. The Master Code will be supplied to you

by your installer. All keypad entries are made by pressing one key at a time.

All access codes can be programmed by following the procedure outlined in "Programming Access

Codes” on page 8.

NOTE: An access code can be a four- or six-digit number, depending on how your installer

has programmed your system. Ask your installer for more information regarding access

codes.

Upon entering through a designated Exit/Entry door, the keypad will

beep and the entry delay will commence, reminding you to disarm

the system. For UL installations, the maximum entry delay is 45

seconds. The keypad will display the following message:

Enter your access code. If an error is made in entering the code,

enter the code again. When a valid access code is entered, the

keypad will stop beeping. If no alarms occurred while the panel was

armed, and there are no troubles, the display will read:

After about 5 seconds, the system will return to the Ready state and

the display will read:

If an alarm occurred while the system was armed, this message will

be displayed. Use the arrow (< >) keys to view which zones caused

the alarm.

If a zone is still in alarm, the display will show the following message

to indicate that a zone is open:

Upon disarming and if a trouble is present, this message will be

displayed. Use the arrow (< >) keys or press *2 to view which

troubles are affecting the system (see "Viewing Trouble Conditions”

on page 14).

Entry is Active

Disarm System

System Disarmed

No Alarm Memory

System is

Ready to Arm

Alarm Occurred

While Armed <>

Scroll to View

Alarm Memory <>

System Trouble

(*2) to View <>

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

DSC PC1404 v1.1 Instrukcja Użytkownika Strona 10

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa DSC PC1404 v1.1