DSC Power832 PC5015 Instrukcja Instalacji Pobierz pdf (Strona 4)

Features

2 Features

Installation

Installing the Power832

Control Panel

The following steps should be carried

out in the order described below. This

will help reduce the overall installation

time.

Before carrying out any installation

work, it is always advisable to walk the

site and check the proposed location

of all the equipment you are intending

to install.

1. Run all cables from the location

of the detectors or modules back

to the main control panel or zone

expander units.

2. Insert the five nylon studs through

the back of the steel cabinet and

mount the cabinet on the wall. Fit

the control panel to the wall.

Insert the PC5015 PCB onto the

nylon studs until it locks into

place. Connect the two yellow

leads from the transformer into

the AC– in terminals on the PCB.

3. Fit the remote keypad, detectors

and internal & external sounders

in the areas described on the

specification.

4. Connect the mains cable to the

unswitched fuse spur and to the

control panel. DO NOT POWER

UP YET.

Installing the Power832 Control Panel

1 2 3 4 5 6 7 8 9 ... 35 36

Komentarze do niniejszej Instrukcji

Brak uwag