DSC Envoy NT9010 Przewodnik Instalacji Strona 47
- Strona / 68
- Spis treści
- ROZWIĄZYWANIE PROBLEMÓW
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Section 2.3: Changing Other NT9010 Functions
43
Communicator Enabled/Disabled . . . . . . . . . . . . . . . . . . . Section [380], Option [1]
Pulse Dialing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [380], Option [3]
Switch to Pulse Dial . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [380], Option [4]
Post Dial Wait for Handshake. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [161]
Maximum Dialing Attempts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [160]
Communicator Call Direction Options . . . . . . . . . . . . . . . . .Sections [361] to [368]
Busy Tone Detection . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [701], Option [6]
Standard/UL Communications Priority . . . . . . . . . . . . . . . Section [701], Option [8]
Pulse Dialing Make/Break Ratio . . . . . . . . . . . . . . . . . . . . Section [702], Option [1]
Force Dialing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [702], Option [2]
ID Tone Enabled. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [702], Option [5]
2100Hz/1300Hz ID Tone . . . . . . . . . . . . . . . . . . . . . . . . . Section [702], Option [6]
Bell on FTC/Trouble Only . . . . . . . . . . . . . . . . . . . . . . . . . Section [702], Option [8]
Delay Between Dialing Attempts . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [703]
2.3.9
Communicator
Te l e ph o ne
Numbers
The system can call 3 different telephone numbers for communication to central
station. The 1st Telephone Number is the primary number, the 2nd Telephone
Number is the secondary number and the 3rd Telephone Number will back up
the 1st telephone number if enabled.
You can program the 1st Telephone Number using Flash Programming, or in the
Advanced Programming (section [301]). The 2nd and 3rd Telephone Numbers must
be programmed in the Advanced Programming sections.
NOTE:
The 3rd telephone Number will NOT back up the 2nd telephone
Number.
If Alternate Dial is enabled the system will alternate between the 1st and 3rd tele-
phone numbers when attempting to call the central station. If disabled the system
will only attempt to call the 3rd telephone number after failing to communicate on
the 1st telephone number.
NOTE:
For Alternate Dial to work properly the 3rd telephone Number
must be both enabled and programmed.
Telephone numbers can be up to 32 digits which will allow you to add special digits
if required. To program the telephone number enter numbers 0 through 9 as
required. The following is a list of HEX digits which can also be programmed and
the function they perform:
HEX (B) - simulates the [✱] key on a Touch-Tone telephone
HEX (C) - simulates the [#] key on a Touch-Tone telephone,
or end of telephone number marker
HEX (D) - forces the system to search for dial tone
HEX (E) - forces the system to pause for 2 seconds
HEX (F) - end of telephone number marker
1st telephone number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [301]
2nd telephone number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [302]
- Installation 1
- Limited Warranty 2
- Table of Contents 3
- WARNING Please Read Carefully 4
- 1.1.3 Main system 6
- Specifications 6
- 1.1.4 Additional 7
- 1.1.5 Peel-off 8
- Instruction 8
- 1.2.5 Connecting 10
- Chapter 1: Quick Set Up 12
- Section 1.3: Troubleshooting 18
- 2.1.6 Reviewing 22
- Programming 22
- 2.1.7 Exiting 22
- Works For Users 23
- 2.2.2 Access Codes 24
- 2.2.3 Voice Prompt 26
- Interface 26
- 2.2.4 Alarm 27
- Announce 27
- 2.2.5 Arming and 28
- Disarming 28
- 2.2.8 Bell Options 30
- 2.2.9 User 31
- Commands 31
- 2.2.10 Function 35
- 2.2.13 Keypad 38
- 2.2.14 Sleep Mode 39
- 2.3.1 Zone 40
- Definitions 40
- 2.3.13 Talk/Listen-in 53
- 2.3.14 Downloading 55
- 2.3.21 Installer 59
- 2.3.22 Walk Test 60
- Appendix A: Guidelines for 61
- Locating Smoke Detectors 61
- Appendix B: Reporting Codes 62
- Zone Alarm/Restoral Codes 64
- WARNING!: 65
- WLS904P-433 with 66
- Three-Pin Jumper 66
- TOP VIEWSIDE VIEW 67
- Detection Pattern 67
- FCC COMPLIANCE STATEMENT 68
Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa DSC Envoy NT9010
(36 strony)
(16 strony)Mitel M7310N manuals
Owner’s manuals and user’s guides for Telephones Mitel M7310N.
We providing 4 pdf manuals Mitel M7310N for download free by document types: User Manual
Komentarze do niniejszej Instrukcji