DSC Power832 Security System PC5016 Dokumentacja Pobierz pdf (Strona 29)

P R O G R A M D E S C R I P T I O N S

5.10 PGM Outputs

There are 3 different types of Programmable Outputs available. They are listed as follows:

• PGM1 and PGM2 on the main board

• 8 low current outputs available with the PC5208 Output Module

• 4 high current outputs available with the PC5204 Power Supply/Output Module

Programming any of the PGM Outputs is a two step process. First an option from the below list must be

selected for the PGM Output. Second the PGM Attributes must be selected. The following is a list of the

PGM Output Options and PGM Attributes.

5.10.1 PGM Output Options

[01] Burglary and Fire Bell Output

The PGM output will activate when the alarm output is active and will turn off when the alarm output is

silenced. If the alarm output is pulsing the PGM output will pulse as well. This output does not follow the

pre-alert for delayed fire zones.

[02] Utility Output

The PGM output will activate for 5 seconds when the [

][7][1][Access Code] command is entered

(See

Section 3.0 “Keypad Commands”).

[03] Sensor Reset

This option is used to reset power for latching smoke detectors.

The output will normally be active, switched to ground.

The output will deactivate for 5 seconds when the [ ][7][2] command is entered

(See Section 3.0

“Keypad Commands”)

. The keypad buzzer will not sound for the 5 second period.

Refer to the hookup diagram in this manual for wiring instructions.

[04] For Future Use

[05] Partition/System Armed Status

The PGM output will activate when the Partition or System is armed and deactivate when disarmed.

[06] Ready Output

The PGM output will activate when the Partition or System is ready to arm. The output will deactivate when

the system is not secure or upon arming.

[07] Keypad Buzzer Follow

The PGM will activate when any of the following events occur and will remain active for as long as the

keypad buzzer is active:

• Doorchime • Entry Delay • Audible Exit Delay

• Auto-Arm Prealert • 24 Hour Supervisory Buzzer Zone

[08] Courtesy Pulse

Upon arming the PGM output will activate for the duration of the exit delay plus two minutes. Upon entry

the PGM output will activate for the duration of the entry delay plus two minutes. Only one courtesy pulse

output may be programmed on a system.

[09] System Trouble

The PGM output will activate when any of the selected trouble conditions are present. It will deactivate

when all the selected trouble conditions are cleared.

The normal PGM attributes, programmed in Sections [141] to [154] is replaced with the following list for

any output selected as System Trouble:

Light [1] Service Required (battery, bell, general trouble, general tamper, general supervisory)

Light [2] AC Failure

Light [3] Telephone Line Trouble

Light [4] Failure to Communicate

Light [5] Fire Trouble / Zone Fault

Light [6] Zone Tamper

Light [7] Zone Low Battery

Light [8] Loss of Clock

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

Komentarze do niniejszej Instrukcji

Brak uwag

DSC Power832 Security System PC5016 Dokumentacja Strona 29

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa DSC Power832 Security System PC5016